Pinwheel Wreath

Hi! It's been awhile since I have shared a papercraft project with you. Today I am sharing this beautiful pinwheel wreath. I used Pinwheel Star from My Scrap Chick for this wreath.

https://myscrapchick.com/product/pinwheel-star-2206/

MATERIALS

14 inch green flocked Styrofoam wreath

double sided paper (I used Modern Millinery Signature Paper by COLORBOK)

1 inch  and 5/8 inch circle punches (optional)

large brad fasteners

hot glue

2 feet of 3/4 inch ribbon for a hanger (optional)

     I used a 14 inch green flocked Styrofoam wreath from my crafting stash as the base for my wreath. You can use a smaller wreath and use fewer pinwheels if you desire. If you use a plain Styrofoam wreath I would wrap the wreath with 6 feet of ribbon.

     I made approximately 50 pinwheels ranging from 5 inches, to 3.5 inches, to 2.5 inches. (A different wreath base will require a different number of pinwheels.) I used 6 different papers alternating which side faced out. I used a 1 inch circle in the center of the large and medium pinwheels and a small circle in the center of the smaller ones. (You could also use the stars from the file.) The pinwheels are secured in the centers with larger brad fasteners.

    If you want a ribbon for hanging the wreath tie it around the wreath and tie a knot. Leave about six inches, tie another knot, then tie the remaining ribbon into a bow.

 I started with the largest pinwheels, evenly spacing them and alternating their positions and patterns around the wreath. Then I added the medium sized pinwheels, ending with the smallest pinwheels to fill in any empty spaces. I nestled them close together because I didn't want a lot of the base to show.

Here it is hanging on the inside of our front door. Sorry the picture isn't very good.

It may look like this wreath is an awful lot of work, but it actually was quite quick and easy to make. Give one a try!

Thanks for stopping by.

Shirley